above link is banned in my company, I am using truClient, there are some problem
1. after recording say two months later, at the starting of script textbox or controls are unable to initialise, there is need to re-record first one-two steps again then only rest script is working fine, else getting error that textbox or control is not found
2.I use forloop and make iterations say more than 50, after first 10-15 even adding delaying time by 30 seconds after each script, rest all iterations are failed,
this is perticularly for checking 100 urls daily in sanity
this script running ok for 1-10 urls in forloop but If I parameterised and run more than 25-50-100 urls + add enough delay time TruClient protocol failed to complete script at end and coming out of loop in between
1. after recording say two months later, at the starting of script textbox or controls are unable to initialise, there is need to re-record first one-two steps again then only rest script is working fine, else getting error that textbox or control is not found
2.I use forloop and make iterations say more than 50, after first 10-15 even adding delaying time by 30 seconds after each script, rest all iterations are failed,
this is perticularly for checking 100 urls daily in sanity
this script running ok for 1-10 urls in forloop but If I parameterised and run more than 25-50-100 urls + add enough delay time TruClient protocol failed to complete script at end and coming out of loop in between